Enterasys-networks ROAMABOUT RBT-1602 Instrukcja Użytkownika Pobierz pdf (Strona 60)

Mounting the Antenna

3-28 Antenna Installation

Toattachtheantennabrackettotheantenna,performthefollowingsteps:

1. Placetheantennasothatthesidewithscrewholesisfacingup.

2. Usethepolarizationlabelontheupperleftcorneroftheantennatoorienttheantennawith

thecorrectpolarization.

3. Situatetheantennabracketagainsttheantenna,

sothattheendagainsttheantennapivotsin

thesameplaneasthedesiredpolarization.Forexample,ifusingverticalpolarization,this

antennabracketendshouldpivotupanddown.Ifusinghorizontalpolarization,thisantenna

bracketendshouldpivotfromside‐to‐side.

4. Usethefour(yellow)hexnuts,

tosecuretheantennabrackettothebackoftheantenna.

5. Rotatethepivotofthebracketendattachedtotheantennatoadjusttheantennaposition.

Lockbracketindesiredpositionbytighteningnutsoneithersideofbracketendwith

wrenches.

Mounting the 5.8 GHz Panel Antenna to the Mast

Figure 3‐14illustrateshowtomountthe5.8GHzpanelantennatothemast.Table 3‐12liststhe

componentsforthisprocedure.

Tomounttheantennatothemast,performthefollowingsteps:

1. Adjustthesizeoftheopeningbetweenthemastbracketssothatitapproximatesthesizeof

themast.

Turnthecarriageboltnutstowardsorawayfromthemastbrackettoslideittowards

orawayfromtheothermastbracket.

2. Slidemastmountsoverthetopofthemast.

3. Tightenthecarriageboltnutsuntilthemastbracketsgripthemastsnugly.

4. Rotatethepivotofthebracketend

attachedtothemast toadjusttheantennaposition.Lock

bracketendindesiredpositionby tighteningnuts oneithersideofbracketendwith

wrenches.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 91 92

Brak uwag

Enterasys-networks ROAMABOUT RBT-1602 Instrukcja Użytkownika Strona 60